Page 1 of 1

Razor Ground Force Reverse Switch Mod Kit Go-Kart Upgrade

Posted: Fri May 03, 2013 9:16 am
by pomoyka99
Hi, I'm opening this thread because I had many questions about installation of this Switch, so I've decided to put them all into one place.

You can see the switch at eBay http://www.ebay.com/itm/330813640411


We recommend to place the switch on right side of the driver seat,
so when driver wants to back up, he will release accelerator and stop the kart
which will prevent kart from rolling forward while reverse speed is engaged.

Had one complain from customer who installed switch on the left side of the battery box, just by drilling one big hole.
Switch was hit by somebody, and damaged physically.

I'll recommend to install it as on picture attached, so it will be guarded by side rail(tube) and kids won't hit it by their shoes when going into the seat.

If it is hard for you to screw in screws to the seat you can pre-drill holes with smaller drill bit(but it is hard to do it because a guard rail staying on the way of drill).

Post your questions in this topic and I'll will answer them ASAP

Re: Razor Ground Force Reverse Switch Mod Kit Go-Kart Upgrade

Posted: Sat Dec 02, 2017 7:50 am
by Vanmatre
Thanks for the advice, I'll be sure to put the switch on the drivers side!